DC Audio 10K A3 10,000w Mono Block Amplifier

Roll over to magnify and click to enlarge
  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

DC Audio
DC Audio 10K A3
60.00 LBS
Calculated at checkout
Ships within 2 business days

Product Description

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs

We recommend for installation
• 1 upgraded battery under the hood
• 3 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear batterys
• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp
• 2 upgraded aftermarket alternators
• Dash mounted voltage meter

Features Voltage 10.0kw
Output Power (RMS) 4 ohm 14.4V 3,000W x 1
2 ohm 5,500W x 1
1 ohm 10,000W x 1
1 ohm 16V N/A
1 ohm 18V N/A
Input Sensitivity 6V~0.2V
Low Pass Filter Switchable
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response Hz 15-270
Signal to Noise Ratio dB 100
Damping factor 150<
Efficiency @ 4ohm % Over 90%
THD @ 4ohms Less than 0.1%
Fuse Rating 1,000 Amps
Linked Fuse Rating 2,000 Amps
Indicator Power Yes
Protection Yes
Clip Yes
Speaker & Power terminal Mold Type Yes
Power Gauge 0Ga x 3
Heatsink Length 37
Heatsink Width inch/mm 11.5
Heatsink Height 2.6