![SSA Evil6.5" Mid-bass Speaker | Condition: New | Category: Speakers SSA Evil6.5" Mid-bass Speaker | Condition: New | Category: Speakers](https://cdn11.bigcommerce.com/s-a6ac4/images/stencil/210x210/products/3703/10895/EVIL-65-000__21279.1707151488.png?c=2)
![SSA Evil6.5" Mid-bass Speaker SSA Evil6.5" Mid-bass Speaker](https://cdn11.bigcommerce.com/s-a6ac4/images/stencil/160w/products/3703/10890/EVIL-65-003__43878.1635352464.png?c=2)
**Attention**
Some products may be missing or not seen in category. Some are missing option sets. If you don't see the options, please simply tell in the order comments. If you don't see the product your looking for in the correct category, simply use the search bar. Please bare with us while we fix this problem.
Thank you for your understanding while we work diligently on this issue.
The 20.0kw competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt syste…
The 20.0kw competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs
We recommend for installation
• 1 upgraded battery under the hood
• 3 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear batterys
• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp
• 2 upgraded aftermarket alternators
• Dash mounted voltage meter
Features | Voltage | 20.0kw | |
Output Power (RMS) | 4 ohm | 14.4V | 3,000W x 1 |
2 ohm | 5,500W x 1 | ||
1 ohm | 10,000W x 1 | ||
1 ohm | 16V | N/A | |
1 ohm | 18V | N/A | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 1,000 Amps | ||
Linked Fuse Rating | 2,000 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | Yes | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga x 3 | |
Heatsink Length | 37.75 | ||
Heatsink Width | inch/mm | 11.5 | |
Heatsink Height | 2.6 |